I started working on the kit a few weeks ago. Parts were glued and sanded. I skipped taking pictures of the test fit phase and a few other steps, I just didn’t have time. This is also the reason for this late of an update from when I first started working on the kit. This is the second kit of the series I’ve been commissioned to build. I’ve learned a good deal from the Evil kit and that should translate to a much higher quality build for this kit.
Tonight, I again skipped out on the gym for the sake of finishing up Mr Evil. Most of the evening was spent masking the remaining parts for detail painting. Here is the end result of that.
Mini evil update. Last night, I ended up sacrificing my gym time with masking the shiny detail areas then spraying some more paint. The following picture shows the lower abdomen with the color changing properties with pictures of the part from different angles.
Last night, I was able to get some painting done on the kit so I updated the commissions page with pictures that I have been taking over the past two weeks. Starting off, I had to soak the parts in purple power to rid all the residual oils, sanding dust, and any other things that may have stuck onto the surface for the past couple of months. After soaking, I pulled the parts and put them into a water bath, following this, they parts were thrown into fresh water in the ultrasonic cleaner. The cleaner was run and then the parts were dried – ready for priming.
