Dom Barrage Progress May Update

It has been a while since I made an update. Real life got a little busy with a trip to Toronto for a wedding and just being busy. I’ve been getting work here and there with bits and pieces. One of the major bits is the skirt. I had used the original skirt and tons of bondo and plastic to build up the rear skirt. My skills with Blender has gotten better and some slow down at work tempted me to try designing the skirt. Printed out, it’s not perfect and it’s slightly heavier than the bondo version, but it look fairly decent. There is still a decent amount of work needed to meld the piece with the waist which was easier with the bondo piece because it was built up from the original rear skirt. Here is the skirt and a quick mock up with the kit.

This update is fairly large since it has been over a month and a half since my last update. So there’s much more after the jump!

(more…)

Continue ReadingDom Barrage Progress May Update

Back to working on the Dom Barrage (update 3 for those counting)

And now back to our regularly scheduled programming. It has been a decent while since the last update for the Dom. I got interrupted by the Exceed RX-78 thingy as well as a shiny new Form 2 3D printer. The latter bit ties in nicely with this update. Continuing from where I last left off sometime last month; I was still cleaning up the work on the front skirt. I had FDM printed the missile pods and created them so that they can be opened. The skirts were cut and sanded so that the pods can be inserted. Here are a few test pictures. You should be able to see that the two skirts are not identical and will need more work. The area for the lower small pods is a little off too, so more putty work is in store for these parts.

As with the larger missile pods, I made the smaller missile pods in two pieces so that I can display the pods opened or closed. Since the smaller pods have less room to work with such that I cannot install a polycap system. I redesigned the print to have a hole through the two pieces that I can insert a brass rod. Now it’s openable.

More after the jump. (more…)

Continue ReadingBack to working on the Dom Barrage (update 3 for those counting)

RX-78 Gundam Exceed Model Head DONE!

This is easily one of my quickest projects to complete in the past 10 or so years. The tough part was figuring out how to take the damn thing apart, and you can check out the disassembly video here:

Naturally, I need to add lights to the thing so I built a light setup for the eyes and the mohawk piece. I also wanted to lower the light bleed below the eyes so I added some styrene to the face piece just under the eyes. The nose vents are just holes so I covered this area with some plastic as well. Styrene tubes are glued to the back of the eyes to focus the light as well as have a place to slide the eye light assembly.

The complete finishing steps after the jump as well as completed pictures. (more…)

Continue ReadingRX-78 Gundam Exceed Model Head DONE!

Dom Barrage Progress Update 2

Progress slowed down a bit because I spent a few days making a mold of a crappy Thai made resin recast of Faye Valentine that a friend of mine picked up back in 2003. The resin is so brittle and ceramic like in texture that it is near impossible to work with and sand. I had made some casts of the Dom’s leg thruster parts and had extra silicone to make one of the Faye parts and after that one piece, I just fell down the rabbit hole.

But back to work on the kit and like the last post, I will try to keep things organized towards the sections I got work on since the last update. First up is the work on the head. I started with tamiya epoxy putty quick type but that stuff takes a little too long and is pretty hard to sand, so I switched over to the polyester putty. And here are some comparison pictures to the original head. I also got the LED wired up and tested that look as well.

More head work after the jump.
(more…)

Continue ReadingDom Barrage Progress Update 2