Jul 182011
 

This past weekend was a busy one. I’ve been focusing on getting the HGUC Gouf Custom done, so there is a little bit of an update on that front. Saturday was the July build gathering. Normally, the gathering is either smaller because folks are tired from AX and it’s summer so folks are just busy with various summer activities. Or there is an explosion of new folks because of the workshops and panels at AX. But neither was true this time, it was just the normal gathering, about twenty or so came. It was fairly productive too, in comparison with the last build gathering.

On the SCGMC front; we have vendors and trophies. But more about that after the jump.

Continue reading »

Nov 112009
 

Update from the weekend and the past few days. First will be work on the main sniper rifle. I still need to get down and finish up the work on the other weapons. There quite a bit of down time while working on the kit as each layer needs a protective clear coat to sandwich each successive step. The process is fairly tedious, but in the long run, saves rework when mistakes are made or issues of incompatible products cause problems. The process is the following:
Paint cured
– clear gloss is sprayed
– decals
– clear gloss
– panel lines
– clear gloss
– paint chipping
– clear gloss
– filter/fade
– clear flat
– pastel weathering
– final clear flat

Allowing each clear coat to cure over night, the quickest I could complete the kit at this point would be about a week. Down time between curing sessions will allow me to work on the gun and hopefully finish everything some time next week.

Continue reading »