Model Building

GM Diorama Progress: Gouf Custom Focus

A little update on the project as I didn’t work on it at all over the weekend and only started back on it the beginning of the week. I started priming and got two of the three GMs I had on skeweres primed. Then realized that I was planning on painting them all the same color scheme, so since I still don’t have the GM Cannon II done yet, time to back burner the GMs and focus on the Gouf Custom. I figured that if I can finish the Gouf in the next two weeks, I can bring the little guy to Otakon and have it sitting next to the MG Gouf Custom. Since the Gouf was skewered and ready for painting, the parts were primed.

(more…)

Continue ReadingGM Diorama Progress: Gouf Custom Focus
Read more about the article Back to work on the GM Diorama

Back to work on the GM Diorama

So after seeing a post from Angel on ThoseGundamGuys, I finally got the motivational push necessary to find the box that I had last stashed all the mostly sanded GM bits and pieces, and do something about it. Pulling the parts out of the box, I find 3 GMs in minor sub-assembly pieces. Time to sort out what parts belong to what GM, and to see about where I had last left off in the surface prep. I had previously done a decent amount of surface prep, but there were a few areas that still required attention.

After sorting out the parts and sorta putting a few together, I went and disassembled the Wagtail and the Power GM and put them on the skewers. I also took apart the Gouf Custom and put it on skewers. In hindsight, I should have also washed the damn parts before skewering them as they have been in the box for a while and having been handled and worked on; not washing the plastic may prove disastrous when I get down to painting and masking. Putting just these three kits on the skewers also shows that I’ve run out of skewers and I don’t have enough wood blocks. The todo list for tonight when I get off work will be to buy some more bamboo skewers and some wood blocks to create more holders. As well as washing and drying the already skewered pieces.

(more…)

Continue ReadingBack to work on the GM Diorama
Read more about the article Will the SD Nightengale finish in time for AX?

Will the SD Nightengale finish in time for AX?

So, this past week I’ve been working quite a bit on this project. Granted if I had spent this amount of energy earlier on the damn thing it would have been long completed by now. The same could be said for many a projects sitting on the workbench, below the workbench, to the side of the workbench, etc. Well, it’s crunch time and I didn’t really expect to get the sucker finished by AX. I was positive that I would have it done by Otakon. Well, at the time of this posting, all I have left are the decals, panel lines and little bits of detail painting. So, effectively, I could possibly get the little bastard done tomorrow and show it at AX.

(more…)

Continue ReadingWill the SD Nightengale finish in time for AX?
Newer Posts
Older Posts