The parts are soaked for at least 24 hours to ensure that the mold release agent has been completely dissolved off the parts. Following the soak, I clean the parts using an ultrasonic cleaner. Without this cleaner, I would normally take an old toothbrush, dish soap in warm water, and scrub the parts to ensure that all the small detail areas have been cleaned properly. Now with the ultrasonic cleaner, this process is simplified and the scrubbing session cleans the parts much better and more efficiently. The cleaning solution for the ultrasonic cleaner is water with a couple of drops of white vinegar. Other products such as dish soap, industrial cleaner can be used as well.<\/p>\n
After running the cleaner, just take the parts out and dry them on some paper towels. Once dried, the parts are ready for priming.<\/p>\n<\/a>
<\/a><\/p>\n