Spray Can Decanting Tutorial

This is a tutorial for decanting spray cans. Decanting spray cans is the term used for extracting the contents of spray cans for use in an airbrush or handpainting; but for most cases, the use is for airbrushing. There are several reason for doing this. Many modelers like a particular color that is found in spray cans, or that certain products are only available in spray can format such as Mr Super Clear , etc. There are many sites with pictures and worded descriptions of the process. This will just add to that list. There is nothing overly groundbreaking, and I'm following the same method that most folks do to extract the paint.

Here are the steps:

• Gather the necessary items: a straw, the spray can, large cup of hot water, and collecting jar
• Cut the straw to a short length such that the contents of the spray can do not need to travel too far, and has less surface area to get attached.
• Submerge the spray can into the hot water, which will warm the can up. This helps the extraction of the paint
• Once the can is warmed up properly, place the straw over the spray can nozzle, and point the other end of the straw into the collecting jar and spray.
• When the can becomes cold and the spray can starts to spray less paint, reheat the can by submerging it back into the hot water
• Continue to fill the collecting jar, but stop when the bottle is half full.
• Using a stainless steel stirring rod or bamboo stiring rod; place the rod into the jar. At this point you can stop and let the collected paint degas on it's own with the rod sticking into the paint and leaving the jar open. Or you can facilitate the degasing process.
• To facilitate the degasing process, carefully stir the paint using the rod. The liquid will bubble up as the gas escapes and the bottle will cool down considerably during this process. When the bottle cools, submerge it into the hot water to warm up the bottle.
• Once the bottle is warmed up, stir carefully to continue the degasing process. This process will need to be cycled through a couple of times to help degas the liquid.
• Once the liquid has been degased properly, it is ready for use in the airbrush. Thinning is usually not necessary. However, when filling the airbrush cup, only fill it half way, as there may still be gas in the liquid and the airbrushing process make turn the liquid volitle and you will have a nice little exploded mess of paint.

The following video shows the above process.

Get the Flash Player to see this player.

 

 

 

Update Information:

June 2, 2008: New tutorial on decanting the contents of spray cans for use in the airbrush.

 

 

 

Ad Crap: