Gouf Custom Conversion DONE!
Ok, final bits for the progress on the kit and now she’s done. As stated in my previous post, I sprayed the final gloss clear over the parts that morning so that when I got off work, I can get down to applying the panel lines. So I did just that when I got home. The panel lines are done with tamiya enamel black thinned with rosonol lighter fluid. The whole job looks rather messy, but the wash solution is left on the surface to dry for a couple of hours. Angel and I had our little mandate and hit up the local stop for the Kogi Truck that night, then headed off to see The Expendables It was decent as an action movie, cheesy lines, a few finny ones, and decent action; not much to write home about.
A few hours later, the wash solution has dried enough that it’s very simple to wipe away the excess ink using a q-tip and paper towels moistened with lighter fluid.
After wiping everything down, the parts are sprayed with the final flat clear coat and then let to dry and cure over night. Waking up this morning, I got down to the final gluing and assembly of all the parts.
Gator needs his GAT!
And on to the final assembly. Now a little trick I use to avoid the pesky problems of paint scratching while assembling, posing, and positioning the kit is to slide some note card paper into the areas that are prone to rubbing together. This way, I can continue to move and reposition the kit until I find the one I like, without having any paint scratching problems. Once I find the pose and position I like, the note card papers come out, and the surface of the parts are unscathed.
Completed pictures after the jump…